Remarks (Sect. IV).

TM 11-6625-1683-15

maintenance authorized to perform the function

e. Tool Number. This column lists the manu-

listed in column 3. This figure represents the

facturer's part number of the tool followed by the

active time required to perform that maintenance

Federal Supply Code for manufacturers (5 digit)

function at the indicated category of maintenance.

in parentheses.

If the number or complexity of the tasks within

C-5. Remarks (Sect. IV).

the listed maintenance function vary at different

maintenance categories, appropriate "worktime"

a. Reference Code. This code refers to the

appropriate item in section II, column 6.

figures will be shown for each category. The

b. Remarks. This column provides the required

number of task-hours specified by the "worktime"

figure represents the average time required to re-

explanatory information necessary to clarify items

appearing in section II.

store an item (assembly, subassembly, component,

module, end item or system) to a serviceable con-

dition under typical field operating conditions.

This time includes preparation time, trouble-

shooting time, and quality assurance/quality con-

trol time in addition to the time required to per-

form the specific tasks identified for the main-

tenance functions authorized in the maintenance

allocation chart. Subcolumns of column 4 are as

follows :

C -- Operator/Crew

O -- Organizational

F Direct Support

H General Support

D Depot

e. Column 5, ToolS and Equipment. Column 5

specifies by code, those common tool sets (not

individual tools) and special tools, test, and sup-

port equipment required to perform the designated

function.

f. Column 6, Remarks. Column 6 contains an

alphabetic code which leads to the remark in

section IV, Remarks, which is pertinent to the

item opposite the particular code.

C-4. Tool and Test Equipment Requirements

(Sect. Ill).

a. Tool or Test Equipment Reference Code.

The numbers in this column coincide with the

numbers used in the tools and equipment column

of the MAC. The numbers indicate the applicable

tool or test equipment for the maintenance func-

tions.

b. Maintenance Category. The codes in this

column indicate the maintenance category al-

located the tool or test equipment.

c. Nomenclature. This column lists the noun

name and nomenclature of the tools and test

equipment required to perform the maintenance

functions.

d. National/NATO Stock Number. This column

lists the National/NATO stock number of the spe-

cific tool or test equipment.

(Next printed page is C-3)

C-2