TM 11-6625-2398-14-4
APPENDIX B
COMPONENTS OF END ITEM LIST
Section I. INTRODUCTION
characteristics of the item by means of its engineering
B-1. Scope
drawings, specifications, standards, and inspection
This appendix lists integral components of and basic
requirements to identify an item or range of items.
issue items for the AN/TPM-24(V)4 to help you inventory
Following the part number, the Federal Supply Code for
items required for safe and efficient operation.
Manufacturers (FSCM) is shown in parentheses.
B-2. General
d. Description. Indicates the Federal item name
This Components of End Item List is divided into the
and, if required, a minimum description to identify the
following sections:
item.
a. Section II. Integral Components of the End Item.
e. Location. The physical location of each item
Not applicable.
listed is given in this column. The lists are designed to
inventory all items in one area of the major item before
minimum essential items required to place the AN/TPM-
moving on to an adjacent area.
24(V)4 in operation, to operate it, and to perform
f. Usable on Code. Not applicable. "USABLE ON"
emergency repairs. Although shipped separately packed
codes are included to help you identify which component
they must accompany the AN/TPM-24(V)4 during
items are used on the different models. Identification of
operation and whenever it is transferred between
the codes used in these lists are:
accountable officers. The illustrations will assist you with
hard-to-identify items. This manual is your authority to
Code
Used on
requisition replacement BII., based on TOEIMTOE
authorization of the end item.
g. Quantity Required (Qty Reqd). This column lists
B-3. Explanation of Columns
the quantity of each item required for a complete major
a. Illustration. This column is divided as follows:
item.
(1) Figure number.
Indicates the figure
h. Quantity. This column is left blank for use during
number of the illustration on which the item is shown.
an inventory. Under the Rcvd column, list the quantity
(2) Item number. The number used to identify
you actually receive on your major item. The Date
item called out in the illustration.
columns are for your use when you inventory the major
b. National Stock Number. Indicates the National
item at a later date; such as for shipment to another site.
stock number assigned to the item and which will be
used for requisitioning.
c. Part Number. Indicates the primary number
used by the manufacturer, which controls the design and
(Next printed page is B-2)
B-1
Previous Page
