TM 11-6625-2398-24P-2
SECTION I.
INTRODUCTION
Code
Definition
1. Scope
PA Item procured and stocked for anticipated or
This manual lists spares and repair parts, special tools;
special test, measurement, and diagnostic equipment
known usage.
XD A support item that is not stocked. When required,
(TMDE), and other special support equipment required
for performance of organizational, direct support, and
item will be procured through normal supply
general support maintenance of the AN/TPM-24(V)2. It
channels.
authorizes the requisitioning and issue of spares and
NOTE
repair parts as indicated by the source and maintenance
Cannibalization or salvage may be used as a
codes.
source of supply for any items source coded
2. General
above except those coded XA and .aircraft
This Repair Parts and Special Tools List is divided into
support items as restricted by AR 700-42.
the following sections:
(2) Maintenance code Maintenance codes
a. Section II. Repair Parts List A list of spares
are assigned to indicate the levels of maintenance
and repair parts authorized for use in the performance of
authorized to USE and REPAIR support items. The
maintenance. The list also includes parts which must be
maintenance codes are entered in the third and fourth
removed for replacement of the authorized parts. Parts
positions of the Uniform SMR Code format as follows:
lists are composed of functional groups in numeric
(a) The maintenance code entered in the third
sequence, with the parts in each group listed in figure
position will indicate the lowest maintenance level
and item number sequence.
authorized to remove, replace, and use the support item
b. Section III SpecLal Tools LLst Not
The maintenance code entered in the third position will
applicable
indicate one of the following levels of maintenance:
c. Section IV. National Stock Number and Part
Code
Application/Explanation
Number Index. A list, in National item identification
O Support item is removed, replaced, used at the
number (NIIN) sequence, of all National stock numbers
organizational level.
(NSN) appearing in the listings, followed by a list, in
H Support item is removed, replaced, used at the
alphameric sequence, of all part numbers appearing in
general support level.
the listings. National stock numbers and part numbers
D Support items that are removed, replaced, used at
are cross-referenced to each illustration figure and item
depot, mobile depot, specialized repair activity
number appearance.
only.
3. Explanation of Columns
(b) The maintenance code entered in the fourth
a. Illustration This column is divided as
position indicates whether the item is to be repaired and
follows:
identifies the lowest maintenance level with the capability
(1) Figure number. Indicates the figure
to perform complete repair (i.e., all authorized
number of the illustration on which the item is shown.
maintenance functions). This position will contain one of
(2) Item number. The number used to
the following maintenance codes:
identify item called out in the illustration
Code
Application/Explanation
b
Source, Maintenance, and Recoverability
H The lowest maintenance level capable of complete
(SMR) Codes.
repair of the support item is the general
(1) Source code Source codes indicate the
support level.
manner of acquiring support items for maintenance,
repair, or overhaul ot end items. Source codes are en-
tered in the first and second positions of the Uniform
SMR Code format as follows:
1
Previous Page
