ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT, AND
DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST
Section I. INTRODUCTION
(1) Source code. Indicates the manner of ac-
quiring support items for maintenance repair, or overhaul
This appendix lists repair parts and special tools required
of end items. Source codes are-
for the performance of organizational, direct support,
general support, -and depot maintenance of the AN/TPM-
PA-Item procured and stocked for anticipated or known
PB-Item procured and stocked for insurance purposes
This repair parts and special tools list is divided into the
because essentiality dictates that a minimum
quantity be available in the supply systems.
a. Repair Parts for Organizational Maintenance-
PC-Item procured and stocked and which otherwise could
Section II. A list of repair parts authorized for the
be code PA except that it is deteriorative in
performance of maintenance at the organizational level.
b. Special Tools, Test and Support Equipment for
PD-Support item, excluding support equipment, procured
Organizational Maintenance. Not applicable.
for initial issue or outfitting and stocked only for
c. Repair Parts for Direct Support, General Support,
subsequent or additional initial issues or out-
and Depot Maintenance-Section III. A list of repair parts
fittings. Not subject to automatic replenishment.
authorized for the performance of maintenance at the
PE-Support equipment procured and stocked for initial
direct support, general support, and depot level.
issue or outfitting to specified maintenance repair
d. Special Tools, Test and Support Equipment for
Direct Support, General Support, and Depot Maintenance
PF-Support equipment which will not be stocked but
- Section IV. A list of special tools, test and support
which will be centrally procured on demand.
equipment authorized for the performance of
PG-Item procured and stocked to provide for sustained
maintenance at the direct support, general support, and
support for the life of the equipment. It is applied
to an item peculiar to the equipment which
e. Index-Federal Stock Number Cross-Reference to
because of probable discontinuance or shutdown
Figure and Item Number or Reference Designation
of production facilities would prove uneconomical
Section V. A list of Federal stock numbers in ascending
to reproduce at a later time.
numerical sequence, followed by a list of reference
KD-An item of depot overhaul/repair kit and not
numbers appearing in ascending alphanumeric sequence,
purchased separately. Depot kit defined as a kit
cross-referenced to the illustration figure number and
that provided items required at the time of
overhaul or repair.
f. Index-Reference Designation Cross-Reference to
KF-An item of a maintenance kit and not purchased
Page Number-Section VI. A list of reference designations
separately. Maintenance kit defined as a kit that
cross-referenced to page numbers.
provides an item that can be replaced at
D-3. Explanation of Columns
organization or direct support or general support
a. The following provides an explanation of columns
levels of maintenance.
found in the tabular listings.