TM 11-6625-1683-15
CHAPTER 8
GENERAL SUPPORT TESTING PROCEDURES
1117 (Signal Field Maintenance Shops) and
8-1. General Instructions
TA 11100 (1117) (Allowances of Signal
a. Testing procedures are prepared for use
Corps Expendable Supplies for Signal Field
by Signal Field Maintenance Shops and Sig-
Maintenance Shop, Continental United States).
nal Service Organizations responsible for gen-
eral support maintenance of electronics equip-
a. Test Equipment.
ment to determine the acceptability of re-
I
I
Technical
paired equipment. These procedures set forth
Federal
Nomenclature
manual
stock No.
specific requirements that repaired equipment
must meet before it is returned to the using
TM 11-6625-200-12
ME-26B/U.
organization. These procedures may also be
used as a guide for testing equipment that
TM 11-6625-535 -15-1
AN/USM-140B.
has been repaired at direct support, if the
TM 11-6625-366-15
proper tools and test equipments are available.
TS-352B/U.
b. Comply with the instructions preceding
each chart before proceeding to the chart. Per-
b. Took and Materials. No tools or ma-
form each step in sequence. Do not vary the
terials are required for general support test-
sequence. For each step, perform all the ac-
ing procedures.
tions required in the Control settings columns;
then perform each specific test procedure and
8-3. Modification Work Orders
verify it against its performance standard.
The performance standards listed in the
8-2. Test Equipment, Tools, and Materials
tests (para 8-4 through 8-14) are based on
the assumption that all modification work or-
All test equipment, tools, materials, and
ders have been performed. A listing of current
other equipment required to perform the test-
ing procedures in this chapter are listed in the
modification work orders will be found in DA
following charts and are authorized under TA
Pam 3104.
AGO 7918A
8-1
Previous Page
