TM 11-6625-928-35
supply using a resistive voltage divider. Fabricate
the voltage divider, using the resistors listed in
the three probes shown in figure 3-9 is constructed
from 3 feet of insulated No. 20 wire with a male pin
MS3192A20A soldered on the probe end.
3-12. Modification Work Orders
The performance standards listed in the tests (para
work orders (MWO's) have been performed. A
listing of current modification work orders will be
found in DA Pamphlet 310-7.
3-13. Physical Tests and Inspection
a. Test Equipment and Material. None are
required.
b. Ted Connectionm and Conditions. Remove the
Figure 3-17. Test power supply and voltage divider.
front panel and the chassis assembly from the case.
c. Procedure.
3-28
Change 3
Previous Page
