TM 11-6625-2398-15-3
(6) Repeat step d(2) for plug contact pins 6, 7, and
(5) Connect the GROUND terminal of the megger
to plug contact pin A19.
10.
(6) Repeat step d(2) for plug contact pins A15
(7) Repeat step a(4) for the three tests.
through A18.
(8) Connect the GROUND terminal of the megger
(7) Repeat step a(4) for the four tests.
to plug contact pin 16.
(9) Repeat step d(2) for plug contact pins 14, 17,
(8) Connect the GROUND terminal of the megger
to plug contact pin A23.
19, and 21.
(9) Repeat step d(2) for plug contact pins A21 and
(10) Repeat step a(4) for the four tests.
A22.
(11) Connect the GROUND terminal of the
(10) Repeat a(4) for both tests.
megger to plug contact pin 1.
(12) Repeat step d(2) for plug contact pins 18 and
(11) Connect the GROUND terminal successively
between tests to the respective outer coaxial terminal of
23.
contact pins B1, B3, B5, B7, B9, B11, C1, C3, C5, C7,
C9, and C11.
(13) Repeat step a(4) for both tests.
(12) Concurrently with step f(11), connect the
(14) Connect the GROUND terminal of the
LINE terminal of the megger to the center contacts of
megger to the outer shell of either plug on the cable.
the coaxial terminals.
(15) Repeat step d(2) for plug contact pins 3, 8, 9,
(13) Repeat step a(4) for the twelve tests.
11, 13, and 22.
(14) Connect the GROUND terminal of the
(16) Repeat step a(4) for the six tests.
megger to the outer shell of either plug on the cable.
(17) Repeat step d(8) for plug contact(t pins 3, 8,
(15) Repeat step d(2) for plug contact pins Al
9, 11, 13, 18, 22, and 23. Perform 28 separate tests
through A10, A20, B2, B4, B6, B8, B10, C2, C4, C6, C8,
until all wires have been tested with respect to each
and C10.
other.
(16) Repeat step a(4) for the 21 tests.
h. Cable W48. (fig. 6-18)
(17) Repeat step d(8). Perform 210 separate tests
(1) Connect the GROUND) terminal of the megger
until all wires have been tested with respect to each
to the outer coaxial terminal of pin of plug P2.
other.
(2) Connect the LINE terminal of the megger to
g. Cable W43. (fig. 6-15)
the center coaxial terminal A of plug 1P1.
(3) Repeat step a(3).
(1) Connect the GROUND terminal of the megger
to plug contact pin 2.
(4) Repeat step a(4).
(2) Repeat step d(2) for plug contact pins 4 and 5.
(5) Repeat steps (1), (2) and (4) for:
(3) Repeat step a(3).
P3 to P1-C
AT1(P4) to P1-E
(4) Repeat step a(4) for both tests.
P5 to P1-F
P6 to P1-B
(5) Connect the GROUND terminal of the megger
to plug contact pin 12.
6-5
Previous Page
