connectors. Cable W4 is approximately 1 foot in
b. Cabing. Cables W1 through W4 are parts of
length including connector. All test set cabling is
a branched wiring harness. Cable W5 is a separate
sleeved in heat-shrink tubing and identified as to
cable used for interconnection between the test set
cable designation and mating connector or
and Induction Compass Transmitter T-611 / ASN.
destination.
Cable W5 is stowed beneath the panel when the T-
c . Panel. T h e p a n e l p r o v i d e s t h e m o u n t i n g
611 / ASN is not used in the test setup. Cable W1
surface for all test set controls, test jacks, power-on
is a 5-foot, 115-volt, 400-Hz input power cable with
lamp, and fuse. The left side of the panel has a
leads to be dressed and tinned for connections as
cutout to allow exit of cables W1 through W4.
r e q u i r e d . Cables W2 W3, and W5 are ap-
proximately 4-foot lengths of cable, including
The TS-2644 / ASN has an additional connector
the test sets.
that mates with Amplifier AM-3209 / ASN. This
connection is necessary to supply excitation to
Radio-Magnetic Compass Indicator ID-
ment
998(*) / ASN when testing Gyromagnetic
The following items comprise the operable Test
Compass Set AN/ ASN-43. The TS-2645 / ASN
Facility Sets TS-2644/ ASN and TS-2645 / ASN :
does not provide any interconnections to Heading-
a. Cable W1 is a 5-foot, 115-volt, 400-Hz input
Radio Bearing Indicator ID-1351 / A other than
power cable.
connector 11P1.
b. Cables W2, W3, and W5 are approximately
NOTE
4 feet long including connectors.
The symbol (*) indicates all models of the
c. Cable W4 is approximately 1 foot long in-
equipment.
cluding connector.
Previous Page
