TM 11-6625-2398-14-4
6-5) and fill open pin apertures with spare pins except for
(24) Strip 48 inches of outside jacket and cable
coaxial cable receptacles.
braid from end of cable which will connect to P2 through
(15) Attach plate to rear of connector using
P5 (fig. 7-6, dimension A).
hardware supplied, then attach dust cover bracket to rear
(25) Strip 19/32 inch of jacket from coaxial
plate.
cable (fig. 7-6, dimension B).
(16) Slide 5-1/4-inch-piece of heat shrink
(26) Trim 11/32 inch of braid from coaxial cable
sleeving to the end of the cable, then shrink the sleeving.
leaving 1/4 inch of braid exposed (fig. 7-6, dimension C).
(17) Slide the second 5-1/4-inch-piece of
(27) Strip 1/8 inch of insulation from the end of
sleeving to the end of the cable, then shrink the sleeving.
each wire in the assembly (fig. 7-5, dimension E).
(18) Apply adhesive (R.T.V.
728 or
(28) Slide four-fingered boot over cable so that
equivalent), under end of sleeving. Slide the 6-1/4-inch-
one coaxial cable fits in each finger of the boot.
piece of sleeving to the end of the cable, then shrink the
(29) Cut a piece of heat shrink sleeving 47-1/4
sleeving.
inches in length.
(19) Clean end of cable covered by heat shrink
(30) Slide the sleeving over the appropriate
sleeving.
coaxial cable and under the applicable finger of the boot.
(20) Apply thermo fit to area to be covered by
(31) Position the appropriate tag marker on the
boot.
sleeving approximately 7 inches from the end of the
(21) Slide boot up to the bracket and shrink the
coaxial cable.
boot.
(32) Disassemble new or salvaged connector
(22) Remove excess adhesive from boot.
(23) Attach the dust cover to the connector.
Figure 7-6.Stripping Details, Cable !A1W5P2 through P5.
(33) Slide outer ferrule over end of cable (fig. 7-
(36) Install cable assembly ino body so that
inner ferrule portion slides under braid. Push cable
8, view A).
(34) Flare the cable braid slightly, do not comb
assembly forward until contact snaps into place in
out braid (fig. 7-8, view B).
insulator. Slide outer ferrule over braid and up against
(35) Place contact on end of cable so that it
connector body (fig. 7-8, view C).
butts against cable insulation, and crimp contact.
7-7
Previous Page
