TM 11-6625-2398-14-4
Figure 7-3. Stripping Details, Cables 1A1 W3 and W4 and W6 through WIO.
(3) Place tag marker over outside of cable
(8) Bend braid back over clamp and trim
excess braid. Make sure braid does not extend past
jacket.
(4) Strip 7/32 inch of insulation from both
shoulder of braid clamp (fig. 7-4, view D).
ends of the cable (fig. 7-3, dimension B).
(9) Tin cable end, inner conductor (fig. 7-4,
(5) Obtain new connector or salvage
view E).
connector from defective cable assembly. Disassemble
(10) Solder contact to center conductor making
the connector (fig. 7-4, view A).
sure outside surfaces are free of solder. Avoid use of
(6) Slip clamp nut, washer, and gasket over
excessive heat. Contact should be flush against cable
cable (fig. 7-4, view B).
dielectric (fig. 7-4, view F).
(7) Comb out braid smoothly and taper over
dielectric. Slide braid clamp over braid and push back
against cable jacket (fig. 7-4, view C).
7-4
Previous Page
