TM 11-6625-2398-14-4
wire in the cable may be substituted. If a cable is broken
(2) Slide cable clamp and rubber buffer away
from connector so that inner conductors in the cable are
it must be spliced by placing a male connector on one
exposed.
side of the break and a female connector on the other.
(3) Use Bendix 11-8675-12 extraction tool
7-8. Repair of Cable lA1Wl (SM-D-787808)
inserted into rear of connector to remove socket from
a. Description of Cable. Cable lAlW1 (SM-D-
conductor.
787808) is a 10 foot multiconductor cable having 11
(4) Cut wire as close to the socket as
conductors and one connector.
The connector
possible.
(MS2746E21BllS) contains 11 No. 12 sockets, of which
(5) Trim insulation 3/16 inch (fig. 7-2).
all are used. All wires are No. 12 gauge. For color of
(6) Insert wire into new socket and crimp with
wires connected to each socket, see schematic diagram
MS3191-4 crimping tool and MS3191-9T positioner.
of cable (fig. 6-2).
(7) Insert new socket into connector using 11-
b. Cable Repair Procedures.
8674-12 insertion tool.
(1) Loosen two screws on cable clamp and
(8) Slide cable clamp with rubber buffer into
unscrew (counterclockwise rotation) cable clamp from
position on connector.
connector.
Figure 7-2. Stripping Details, Cables IAI WI and W2.
(9) Screw (clockwise rotation) cable clamp
7-10. Repair of Cables 1A1W3 and W4 (CG-3750)
onto connector.
a. Description of Cable. Cables 1AlW3/W4 (CG-
(10) Tighten two screws on cable.
3750) are 6-foot RG-214/U cables with connectors on
7-9. Repair of Cable 1A1W2 (SM-D-787809)
each end (fig. 6-4). Connector P1 is M39012/01-0002
a. Description of Cable. Cable 1A1W2 (SM-D-
and P2 is M39012/02-0002.
Dust caps for each
787809) is a 10-foot multiconductor cable having three
connector are attached to the cable.
b. Repair of Cable. The following procedures apply
conductors and one connector.
The connector
(MS27467E17B6S) contains six No. 12 sockets of which
for either end of the cable.
three (A, B, and C) are used.
Sockets D, E, and F are
(1) Cut a 72-inch length of RG-214/U cable.
spares. The three conductors are No. 12 gauge wire,
(2) Strip 11/32-inch of outside jacket from
colored Black, White, and Green and are connected to
both ends of cable (fig.
sockets A, B, and C, respectively (fig. 6-3).
b. Repair of Cable. Repair of cable SM-D-787809
is the same as that for cable SM-D-787808, as described
7-3
Previous Page
