TM 11-6625-1683-15
CHAPTER 9
SHIPMENT AND LIMITED STORAGE AND DEMOLITION TO
PREVENT ENEMY USE
Section I. SHIPMENT AND LIMITED STORAGE
f. Stow the power cord by wrapping it on
9-1. General Information
the stowage hooks on the test panel (fig. 9-1)
For shipment or limited storage of the MK-
in an X pattern, and secure the loose end by
980/PPS5 check its physical and operating
pressing the clip (on the plug) onto the adja-
condition (para 45), stow all the accessories
cent portion of the cord. Make sure the cord is
inside the case and close it (para 92), and put
dressed to pass inside the test panel handle,
t h e MK980/PPS5 in a wooden packing
so that it will not prevent the top half of the
box (para 9-3).
case from seating properly on the bottom half.
9-2. Stowing Test Facilities Kit
next to the bottom half so that the hinges are
MK980/PPS-5 In Case
adjacent to the hinge pins, lift and tilt the top
has been
the M K - 9 8 0 / P P S - 5
After
half toward the bottom half so that the hinges
checked (para 45) and all components are at
engage the hinge pins, and close the case by
hand or accounted for, (app B), proceed as
swinging the top half over and down on to the
follows:
bottom half.
h. Secure the eight latches as follows: press
cessory kit pouch (fig. 11).
and hold each latch hook against the side of
b. Stow the accessory kit pouch and a copy
the case, pull the latch tab out and up, and
of this technical manual in the accessory kit
turn the tab clockwise one-half turn. Make
compartment.
sure each latch hook engages the latch groove
as it rises when the tab is turned.
c. Close the accessory kit compartment by
lowering the retaining plate into place and se-
curing it with the two quarter-turn fasteners.
9-3. Repackaging Test Facilities Kit
(To lock a fastener, press it down and turn it
MK-980/PPS-5 For Shipment or
clockwise one-quarter turn.)
Limited Storage
d. If the SB3004/PPS5 test panel is con-
The exact procedure for repackaging de-
nected to 1115 volts ac, disconnect the power
pends on the materials available and the con-
cord from the ac outlet.
ditions under which the equipment is to be
shipped or stored. Whenever possible, adapt
e. If the test panel is connected to Battery
the following materials and procedures.
Box CY-3871/PPS-5 or to Power Supply PP-
4450/PPS5, disconnect the battery cable or
a. Materials. The materials listed in the
the power supply cable from the test panel 6
chart below are required for repackaging test
VDC jack by pulling the lanyard attached to
Facilities Kit MK980/PPS5. For stock num-
the plug. Place the protective cap on the plug.
bers of materials, refer to SB 38-100.
9-1
Previous Page
