C2, TM 114625-1683-15
(18) Modulator load, Preamplifier adap-
cal Lead CX10449/PPS-5. Leak-
ter, coaxial and test lead assemblies.
a g e should be greater than 10
megohms to ground.
end to end. Use the RX1 range on
(C) Perform high-pot tests on the fol-
Multimeter ME26 ( * )/U. The re-
lowing assemblies. The indicated
sistance should be less than 0.1
voltages should be applied for 1
ohm except on Radio Frequency
minute.
Cable Assembly CG3355/U, where
the resistance should be 150 ohms
5 percent. Resistance from P2 to
ground should be 51 ohms 5 per-
cent.
(b) Perform a leakage test on Electri-
Figure 8.1-1. Test setup with ac input power to Electrical Test Panel SB-3004/PPS-5.
8.1-14
Previous Page
