C2, TM 11-6625-1683-15
(b) Perform a leakage and higkpot
(6) C X - 1 0 4 3 2 PPS-5 cable a s s e m b l y
test between pins A and B of P1
(blocks 600 and 900).
Leakage should be greater than 10
(a) Perform a continuity test between
ac for 1 minute.
each pin of PI and the correspond-
ing pin of P2. Use the RX1 range
(9) CX-10435/PPS-5 cable assembly
on Multimeter ME26(*)/U. The
(block 1000).
resistance should be less than 0.1
(a) Perform a continuity test between
ohm.
each pin of P1 and the correspond-
(b) Perform a leakage and high-pot
ing pin of P2. Use the RX1 range
test from each pin of P1 to all
on Multimeter ME26 ( * ) /U. The
other pins of P1 and to each con-
resistance should be less than 0.1
nector hood. Leakage should be
ohm.
greater than 10 megohms. High-
(b) Perform a leakage and high-pot test
pot at 500 volts ac for 1 minute
from each pin of P1 to all other
except pin 8, which should be
pins of P1 and to each connector
high-potted at 700 volts ac for
hood. Leakage should be greater
1 minute.
than 10 megohms. High-pot at 500
volts ac for 1 minute.
(7) CX-10433 PPS-5 cable assembly
(10) C X - 1 0 4 3 6 / P P S - 5 c a b l e a s e m b l y
(block 1200).
(block 2400).
(a) Perform a continuity test between
(a) Perform a continuity test between
each pin of P1 and the correspond-
each pin of P1 and the correspond-
ing pin of P2. Use the RX 1 range
ing pin of P2. Use the RXI range
on Multimeter ME-26(*)/U. the
on Multimeter ME26 ( * ) /U. Re-
resistance should be less than 0.1
sistance should be less than 0.1
ohm.
ohm.
(b) Perform a leakage and high-pot
(b) Perform a leakage and high-pot
test from each pin of P1 to all other
test from each pin of P1 to all
pins of PI and to each connector
other pins of P1 and to each con-
hood. Leakage should be greater
nector hood. Leakage should be
than 10 megohoms. High-pot at 500
greater than 10 megohms. High-
volts ac for 1 minute.
pot at 500 volts ac for 1 minute.
(8) CX-10434/PPS-5 cable assembly
(11) CX-10443 PPS-5 cable assembly
(block 1000).
(CRT TEST) .
(a) Perform a continuity test between
(a) Perform a continuity test between
each pin of P1 and the correspond-
the pins as tabulated below. Use
ing pin of P2. Use the RX1 range
the RX1 range of Multimeter ME
on Multimeter ME26 ( * )/U. The
26 (*)/U. The resistence should be
resistance should be less than 0.1
less than 0.1 ohm.
ohms.
8.1-11
Previous Page
