C3,
TM
11-6625-1683-15
sistance should be less than 0.1
ohm.
(b) Perform a leakage and high-pot
test from each pin of P1 and P2
to all other pins of both P1 and
P2 to each connector assembly
frame. Leakage should be greater
than 10 megohms. High-pot at 500
volts ac for 1 minute.
(5) CX-10431 PPS-5 cable assembly
(blocks 100 and 2800).
each pin of PI and the correspond-
ing pin of P2, Use the RX1 range
on Multimeter ME-26(*)/U. Re-
sistance should be less than 0.1
ohm.
(b) Perform a leakage and high-pot
test from each pin of P1 to all
other pins of P1 and to each con-
nector hood. Leakage should be
greater than 10 megohms. High-
pot at 500 volts ac for 1 minute,
8.1-10.1
Previous Page
